Leadshine Легко Сервопривод Сразу 220 или 230 Вход ПЕРЕМЕННОГО ТОКА от 0.5 до 6.0A Load Based Выходной Ток

Same as servo drives in traditional brushless servo systems, an ES-DH2306 easy servo drive takes encoder feedback from a driven ES-MH series easy servo motor to close the position loop and eliminate the possibility of lose of movement synchronization. Therefore, loss of steps which limits adoption of stepper systems is totally eliminated in ES-DH2306 driven easy servo systems. Compared with constant output current in open loop stepper drive, output current from an ES-DH2306 servo drive to the driven motor is load based. When torque requirement is low, the output current is automatically lowered to the level of "just enough". But when the torque requirement is high, an ES-DH2306 easy servo drive can boost the output current quickly, up to 6.0A. This can significantly improve control system response time, offer excellent acceleration performance, and reduce motor heating by as much as 50% over open-loop stepper systems. Also, there is no torque reservation needed for an ES-DH2306 driven easy servo system. In an ES-DH2306 driven easy servo system, it always allows 100% torque implementation available from the driven easy servo motor and thus improves system high speed performance by as much as 30% over comparable open loop stepper systems. In addition, smoothness and quietness are also significantly improved in ES-DH2306 driven easy servo systems over steppers.

Compared with traditional brushless servo systems, cost for ES-DH2306 driven easy servo systems is significantly lower. Starting and low-speed huge output torque from an EM-DH2306 driven easy servo motor is way higher than torque from simliar size brushless servo motors. Such systems also outperform comparable traditional brushless servo systems for high standstill stiffness, no hunting (shaking), no overshooting, almost zero settling time, and plug-and-play setup with no tuning for most applications. In addition, plug-and-play setup for almost all applications makes ES-DH2306 driven easy servo system much simple to set up, over hard-to-configure brushless servo systems which usual involve configurations of tens of parameters.

When an ES-DH2306 easy servo drive is implemented with a Leadshine ES-MH series easy servo motor, there is No Configuration Needed for almost all applications. For fine tuning or custom configurations, a user can simply use the on-board LED display to perform all the setup.

Matching Table